Konfigurasi Event CLI

Kali ini kita akan coba EEM based on command CLI,

Untuk topology masih sama, berikut konfigurasinya :

R1(config)#event manager applet SHOW_INTERFACE_UP

R1(config-applet)#event cli pattern "show ip interface brief" sync yes

R1(config-applet)#action 1.0 cli command "enable"

R1(config-applet)#action 2.0 cli command "show ip interface brief | include up"

R1(config-applet)#action 3.0 puts "$_cli_result"

R1(config-applet)#action 4.0 set $_exit_status "0"

Lakukan debug pada R1

R1#debug event manager action cli

Debug EEM action cli debugging is on

Coba verifikasi interface dan lihat output nya.

R1#show ip interface brief

FastEthernet0/0..........................12.12.12.1 YES manual up up

Loopback0 1.1.1.1 YES manual up up R1#

*Feb 7 08:07:22.327: %HA_EM-6-LOG: SHOW_INTERFACE_UP : DEBUG(cli_lib) : :

CTL : cli_open called.

*Feb 7 08:07:22.335: %HA_EM-6-LOG: SHOW_INTERFACE_UP : DEBUG(cli_lib) : :

OUT : R1>

*Feb 7 08:07:22.335: %HA_EM-6-LOG: SHOW_INTERFACE_UP : DEBUG(cli_lib) : : IN

: R1>enable

*Feb 7 08:07:22.347: %HA_EM-6-LOG: SHOW_INTERFACE_UP : DEBUG(cli_lib) : :

OUT : R1#

*Feb 7 08:07:22.347: %HA_EM-6-LOG: SHOW_INTERFACE_UP : DEBUG(cli_lib) : :

: R1#show ip interface brief | include up

*Feb 7 08:07:22.383: %HA_EM-6-LOG: SHOW_INTERFACE_UP : DEBUG(cli_lib) : :

OUT : FastEthernet0/0........................ 12.12.12.1 YES manual up up

R1#

*Feb 7 08:07:22.383: %HA_EM-6-LOG: SHOW_INTERFACE_UP : DEBUG(cli_lib) : :

OUT : Loopback0 1.1.1.1 YES manual up up

*Feb 7 08:07:22.383: %HA_EM-6-LOG: SHOW_INTERFACE_UP : DEBUG(cli_lib) : :

OUT : R1#

*Feb 7 08:07:22.387: %HA_EM-6-LOG: SHOW_INTERFACE_UP : DEBUG(cli_lib) : :

CTL : cli_close called.

Seperti yang kita lihat ketika kita mengetik show ip interface brief maka output yang

keluar hanya interface yang up saja.

configsantuy